Safety Instructions; Technical Data - AL-KO R35 Manual De Instrucciones

en
INSTALLATION
For drawbar:
Type R35
Bolting the drawbar to the axle and clamp
connection
Drawbar connection profile (a)
Fit the drawbar with two M16 hexagon
bolts.
Bolting the drawbar to the trestle and
clamping bracket
Attach the clamping bracket to the frame
(front edge of the assembly) using two
M16 - 8.8 bolts.
CAUTION!
Observe the length ratio (L1 : L 2 < 2,5)!

SAFETY INSTRUCTIONS

CAUTION!
The tightening torques must be checked after 100 km and retightened to the prescribed values
if necessary!

TECHNICAL DATA

Type
Drawbar, rectangular hollow section
Recommended bolts
Tightening torque
4
A
B
L
L
L L
R35
120 x 120 mm
M16 - 8.8
M16 -195 Nm
a
-
A B
1311214_b