ECS B85H3-M9 Manual Del Usuario

Disclaimer
The information in this document is subject to change without notice. The
manufacturer makes no representations or warranties with respect to the contents
hereof and specifically disclaims any implied warranties of merchantability or
fitness for any particular purpose. The manufacturer reserves the right to revise this
publication and to make changes from time to time in the content hereof without
obligation of the manufacturer to notify any person of such revision or changes.
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna
•
• Increase the separation between the equipment and the receiver
Connect the equipment onto an outlet on a circuit different from that to
•
which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
•
Shielded interconnect cables and a shielded AC power cable must be employed with
this equipment to ensure compliance with the pertinent RF emission limits
governing this device. Changes or modifications not expressly approved by the
system's manufacturer could void the user's authority to operate the equipment.
Declaration of Conformity
This device complies with part 15 of the FCC rules. Operation is subject to the follow-
ing conditions:
• This device may not cause harmful interference.
This device must accept any interference received, including interference
•
that may cause undesired operation.
This device is in conformity with the following EC/EMC directives:
Limits and methods of mesurement of radio disturbance char-
EN 55022
acteristics of information technology equipment
EN 61000-3-2
Disturbances in supply systems caused
Disturbances in supply systems caused by household appli-
EN 61000-3-3
ances and similar electrical equipment " Voltage fluctuations"
EN 55024 Information technology equipment-Immunity characteristics-
Limits and methods of measurement
Safety for information technology equipment including electri-
EN 60950
cal business equipment
CE marking
B85H3-M9 USER MANUAL