RUN
When unit's compressor is running, this indicator light will illuminate to signify that cooling mode is currently in
operation.
Setting the temperature Control
Upper zone adjustable temperature: 5°C to 10°C (40°F to 50°F)
Lower zone adjustable temperature: 10°C to 18°C (50°F to 64°F)
Please note: For optimal performance, the difference of temperatures set in the two zones should be with the
range 4~8°C
Set the desired temperature by pressing the corresponding buttons, Left
press is in 1-degree increment. Once released, set temperature will flash for approximately 5 seconds then revert
back to display the internal temperature.
To view your set temperature, press either the
seconds.
Note: The temperature inside may vary slightly depending on whether or not the interior bulb is ON or OFF and
where the bottles are located (upper/middle or lower section).
ECO mode:
Press and hold the button
In this mode, the interior LED light, the compressor indicator
will be turned off and the symbol ° will illuminate on the upper left corner of °C / °F.
Light
LED lamp brightness mode: with Memory IC (when unit restarts after power failure unit, will auto recover to last
setting), the default brightness is 100%.
Each time the button
75%, 50%, OFF)
Temperature Conversion
The appliance has the capability to display temperature in either Celsius or Fahrenheit. To change the temperature
scale, press and hold both
for 3 seconds to enter or exit ECO mode.
is pressed, the brightness of the LED will be cycled through the four positions (100%,
buttons simultaneously for approx. 3 seconds.
button once and LED display will flash set temperature for 5
and the temperature value on the display panel
10
or right
to decrease. Each