Important Safety Instructions - MCS MASTER DF 48 P Manual De Instrucciones Para El Uso Y Mantenimiento

1... IMPORTANT SAFETY INSTRUCTIONS

2... OPERATING INSTRUCTION
3... MAINTENANCE
►► IMPORTANT SAFETY INSTRUCTIONS
►
CAUTION: READ AND FOLLOw ALL INSTRUC-
TIONS BEFORE OPERATING THIS FAN.
Use the fan only as described in this manual. Misuse may
cause a fire or an electrical shock.
► 1. Make sure the power supply cable has not been dam-
aged. If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard. Moreover, check if the
technical parameters of power supply source comply with
the requirements specified on the rating plate.
► 2. Close supervision is necessary when this fan is used
near children, the elderly and pets.
► 3. Always turn the fan off after use, before cleaning, or
moving location.
► 4. Do not insert fingers or other objects into the fan
guard.
► 5. Do not operate the fan in areas where petrol, paint or
other flammable liquids are used or stored.
► 6. Do not place the fan near an open flame, cooking or
heating appliance, or hot surface.
► 7. This fan is not intended for use in wet or damp loca-
tions. Never locate the fan in an area where it may fall into
a bath or other water container.
► 8. Always use on a dry, level surface.
► 9. Do not let the power cord hang over the edge of a
table or counter.
► 10. Arrange the cord away from an area where it may
be tripped over.
► 11. Never place the power cord under a carpet or rug.
► 12. To disconnect from the power supply, grip the plug
and pull from the power socket. Never pull by the cord.
► 13. This fan should not be operated outside.
► 14. Do not operate without fan guard properly in place.
► 15. Do not cover the fan during operation.
► 16. Do not leave the unit unsupervised during opera-
tion.
►► OPERATING INSTRUCTION
►
To adjust airflow upward or downward: Tilt the fan head to
the desired angle by hand easily. Air speed control: Turn
the SWITCH to I LOW or II HIGH position to set the ap-
propriate air speed.
► 1. The ventilator is fitted with a belt transmission from
the engine to the fan. Whenever you notice belt slipping on
the belt wheels, tighten the belt.
► 2. This fan features an overheat safety cut-out device,
which will automatically shut the fan off should it overheat
for any reason. If this happens immediately unplug the fan
from the power socket.
►► MAINTENANCE
►
► 1. Before cleaning turn the fan off and unplug from the
power supply.
► 2. To clean the fan use a soft cloth to wipe off any dust.
If the fan is very dirty use a damp cloth and wipe dry. Do not
PARAGRAPH SUMMARY
use any cleaning detergents, sprays or other chemicals, as
they will damage the plastic.
► 3. Store the fan in the original packaging in a ventilated
dry area.
► 4. The motor bearings are permanently sealed and do
not require additional lubrication.
wARNING
Do not operate the fan with a damaged cord or plug, after
the fan malfunctions, has been dropped or damaged.
Do not use extension cords with this product!
To reduce the risk of fire or electrical shock, do not use the
product with a solid state speed control device.
CAUTION
Automatically operated device-To reduce the risk of injury
disconnect from power supply before servicing.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capa-
bilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
en
it
de
es
fr
nl
da
fi
no
sv
pl
ru
cs
hu
sl
hr
lt
lv
et
ro
sk
bg
uk