König KN-RFRIKIT Manual De Instrucciones página 2

ENGLISH
The radio control units included in the packaging are already programmed in bistable
mode and ready to use. To reprogram the remote controls, please follow below steps.
RECEIVER
Programming the König receiver or additional remotes:
(To be performed on the receiver, picture 1)
The receiver can be programmed into: monstable or bistable mode
This König remote can be programmed to control output 1 and output 2 of the receiver in
bistable or monostable mode.
Example1: With the monostable mode, you can sent out a pulse to the central unit of an
automatic gate and open it.
Example 2: With the bistable mode, you can switch on a device (like a lamp) by pressing
the button one time, to switch off the device you have to press the same button once
again.
Example 3: If you use the monostable mode with a lamp, you push the button to switch on
the lamp, but when you release this button the lamp switches off.
So, you only should use the monostable mode if you need a pulse, otherwise you have to
use the bistable mode.
STEP 1:
Press the P1 button on the receiver:
1 time to program output 1 in monostable mode.
2 times to program output 2 in monostable mode.
3 times to program output 1 in bistable mode.
4 times to program output 2 in bistable mode.
STEP 2 (perform immediately after step 1 is carried out):
Keep pressing button A or B on the König remote (picture 2) that you want to sync until
the LED on the receiver begins to flash.
Erasing codes
There are two types of erasing.
A: Erasing of an individual code:
Press key P2 for approx. 2 seconds (release the key); the LED will light up, press the key on
the König remote control you would like to delete.
B: Erasing all acquired codes:
Press key P2 until the LED lights up (approx. 8 seconds).