STACK-ON GCB-18C Manual De Instrucciones página 4

Side By Side Shelf Assembly
To assemble two shelves at the same height, assemble the shelves as
shown. It is important to note that you will be using the same screw to
support both shelves through the Center Partition.
Tip: It may be useful to work from the left side of the cabinet and work
towards the right side. We recommend not tightening the screws until
both your shelves are in place.
After selecting the configuration that fits your needs, load the cabinet
with your guns and equipment. If you are satisfied with your cabinet
configuration, proceed with mounting the cabinet to the wall and floor
as described later in these instruction.
SELECTING A LOCATION
The cabinet must be mounted to wall studs and the floor. For
optimal safety and security, the cabinet should be installed adjacent
to the side wall of a closet with minimal space on either side of the
cabinet, in an isolated, dry and secure area. The cabinet should be
flat against the wall at the back of the unit, as well as flat on the floor.
Remove the baseboard if necessary.
THE CABINET SHOULD ALWAYS BE KEPT OUT OF
THE REACH OF CHILDREN.
CENTERS
CABINET
TOP VIEW
MINIMUM
16"
SECURING THE CABINET
Before you install the cabinet to a wall and the floor, install the interior
components as described in the assembly instructions.
NOTE: This cabinet must be mounted to wall studs and the
floor. Failure to do so will compromise the safety and security
of the cabinet.
NOTE: The cabinet must be secured to wall studs in the top holes
in the back of the cabinet so that it is anchored to the wall studs in
two locations. The cabinet must also be mounted to the floor. Use
the hardware provided or consult your hardware retailer for
fastening hardware for your particular mounting surfaces
Drill (2) 3/16" pilot holes into the wall studs lining up with the top
(2) mounting holes in the back of the cabinet. Secure the cabinet to
the wall using (2) lag bolts and washers.
Drill (2) pilot holes and secure the cabinet bottom to the floor with
(2) lag bolts and washers.
Insert the plastic plugs in the cabinet's top mounting holes if you
are not installing the a Pistol-Ammo cabinet on the top of the
security cabinet.
4
21
40112-1309