Meta System LEGOS1 Manual Del Usuario página 14

PANIC (LEGOS 3)
It is possible to trigger a 10 second alarm cycle by pressing the second button on the remote control. This alarm cycle can be interrupted
by pressing the same button again.
SPECIAL FUNCTIONS – CONFIGURATION
It is possible to set some alarm functions to adapt the alarm system to the motorcycle and its driver's needs. To set the functions,
which are described in the table below, proceed as follows:
1. arm the alarm system with the remote control
EN
2. turn the ignition key ON within 10 seconds: the siren will make a BEEP sound to confirm selection
3. press the remote control's button briefly 4 times: the siren will make 4 BOOP sounds to confirm reception of the signal
4. turn the motorcycle's ignition key OFF
5. turn the motorcycle's ignition key ON and then OFF the same number of times as the number of the special function to be set (see
table). Leave the ignition key ON the last time: the LED is on
6. briefly press the button of the remote control once if the settings described in the first column are required (see table - BEEP column)
7. briefly press the button of the remote control twice if the settings described in the second column are required (see table - BOOP
column)
8. turn the ignition key OFF and briefly press the button of the remote control to exit programming mode, otherwise repeat from step 5
to set another function.
TABLE SPECIAL FUNCTIONS – CONFIGURATION
1
Buzzer when arming and disarming
2
Direction indicators when arming and disarming
3 Horn/siren alarm output or control of activation
4
Control of alternate horn or continuous siren
5 Passive arming only of immoboliser or also alarm function
6 Passive arming with movement sensor enabled
7
Alarms of cyclical or single contacts
8
Enabling of automatic arming
(factory settings in bold type )
FUNCTION
14
BEEP BOOP
YES NO
YES NO
Allarm Activation
Alternated Continuous
Also alarm
Immobiliser
YES NO
Derived
Cyclical
YES
NO