Descargar Imprimir esta página

Removing The Cartridge - cosi Cosiscoop Cement Manual De Instrucciones

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
Connecting to a Gas Cartridge
If the gas lantern is fitted to an empty cartridge, then please read "Removing
Cartridge".
Remove the glass and stone before removing the attached cartridge.
This gas lantern is fitted with a sealing washer. Check the sealing washer is
present and in good condition before connecting the cartridge.
Do not use if the seal is damaged or worn.
Do not use appliances that are leaking, damaged or do not function properly.
Only change gas cartridges outdoors or in well-ventilated places away from
naked flames, any other ignition source, and other people.
Close the control valve by turning the knob clockwise (OFF).
Screw out the cartridge cover anticlockwise; attach the gas cartridge and screw in the cartridge cover
clockwise.
Replace stones and glass as instructed, then put a layer of stones in.
The stones shall not cover the burner.
Place the Cosiscoop on a hardened, non-flammable and clean surface
or on a table that can bear weight. Make sure the Cosiscoop is stable
and level.
Hold a long lighted lighter (with a minimum length of 140mm) near
the burner and slowly open the control knob anticlockwise (ON).
If the burner does not light after 5 seconds, turn off gas valve and
wait 1 minute before re-lighting.
If the unit does not light after several attempts, contact your retailer.
Avoid moving the gas lantern once it is lit because this could be
dangerous.
Always operate the gas lantern at least 1 meter away from walls and ceilings and never near
flammable materials.
CAUTION: accessible parts of this gas lantern may become very hot during and after use. Handle with care.
Keep young children away from this appliance.
Extinguish by turning control knob fully clockwise (OFF). Check that the gas lantern is fully
extinguished before leaving unattended.
Always store the gas lantern in a well-ventilated area.

Removing the Cartridge

Only change gas cartridges if they are empty.
Make sure the gas lantern is off by turning the control knob fully anticlockwise (Off) and check that the
gas lantern has been fully extinguished.
Only change gas cartridges outdoors or in well-ventilated places away from naked flames and any
other ignition sources.
Only store and change gas cartridges well away from flammable objects, any ignition sources (candle,
cigarettes, other flame producing appliances), pets and people.
Remove the glass and stone before removing the cartridge.
Dispose of in accordance with the instructions printed on the cartridge.
Screw out the cartridge cover anticlockwise; move the gas cartridge out by hand.
Screw in the cartridge cover clockwise if not connecting to gas.
If there is a smell of gas or you suspect a leak once the cartridge has been
fitted, take the appliance to a well-ventilated outdoor location away from
any ignition sources. If you want to check for leaks in your appliance, do so
outside. Do not try to detect leaks using a flame; use soapy water.
sealing
190 gr gas
cartridge
Lock gas
cartridge
5

Publicidad

loading