Zyxel ZyWALL 5 Manual Del Usuario página 4

5 Look at the front panel. The PWR LED turns on. The SYS LED blinks while performing system testing and
then stays on if the testing is successful. The ACT, CARD, LAN/DMZ and WAN LEDs turn on and stay on
if the corresponding connections are properly made.
2 Accessing the Web Configurator
Use this section to configure the WAN 1 interface for Internet access.
1 Launch your web browser. Enter 192.168.1.1 (the
ZyWALL's default IP address) as the address.
If the login screen does not display, see
9.1 to set your computer's IP address.
3 Change the login password by entering a new
password and clicking Apply.
5 The HOME screen opens.
The ZyWALL is in router mode by default. Continue to the next step if you want to use routing features such as
NAT, DHCP and VPN.
Go to Section 3 if you prefer to use the ZyWALL as a transparent firewall.
6 Check the network status table. If the WAN 1 status is not Down and there is an IP address, go to
5.
If the WAN 1 status is Down (or there is not an IP address), click the Wizard icon and use
configure WAN 1.
ENGLISH
2 Click Login (the default password 1234 is already
entered).
Section
4 Click Apply to replace the ZyWALL's default
digital certificate.
3
Section
Section 4 to