Weston 36-3550-W Manual De Instrucciones página 2

CLEANING CLEANING
CAUTION
Cut Hazard. The cutting plates are sharp. Use care when handling.
w
The use of cut-resistant gloves is recommended when handling the cutting plates.
It is recommended to thoroughly clean your French Fry Cutter before and It is recommended to thoroughly clean your French Fry Cutter before and
after each use. Clean with hot, soapy water, then rinse with clean water and after each use. Clean with hot, soapy water, then rinse with clean water and
dry thoroughly. dry thoroughly.
1. Remove the 3 Thumb Nuts and Washers from the French Fry Cutter. 1. Remove the 3 Thumb Nuts and Washers from the French Fry Cutter.
NOTE: When removing the last Thumb Nut, hold on to the Cutting Plate, NOTE: When removing the last Thumb Nut, hold on to the Cutting Plate,
failure to do so, may result in the Cutting Plate falling causing damage. failure to do so, may result in the Cutting Plate falling causing damage.
2. To clean between the Blades of the Cutting Plate, use a long bristle brush 2. To clean between the Blades of the Cutting Plate, use a long bristle brush
to remove debris. DO NOT use your fingers! to remove debris. DO NOT use your fingers!
3. To remove the Pushing Plate, with the Handle in the down position, remove 3. To remove the Pushing Plate, with the Handle in the down position, remove
the 2 Push Plate Screws from the top of the Pushing Plate (FIGURE 1). the 2 Push Plate Screws from the top of the Pushing Plate (FIGURE 1).
4. Once the Push Plate Screws are removed, raise the Handle and remove 4. Once the Push Plate Screws are removed, raise the Handle and remove
the Pushing Plate. the Pushing Plate.
5. To clean the Push Plate, remove any remaining debris with a blunt object, 5. To clean the Push Plate, remove any remaining debris with a blunt object,
such as a butter knife, then thoroughly clean with a long bristle brush. such as a butter knife, then thoroughly clean with a long bristle brush.
CHANGING THE CUTTING PLATE
w
The use of cut-resistant gloves is recommended when handling the cutting plates.
FIGURE 1 FIGURE 1 1. Remove the 3 Thumb Nuts and Washers from the French Fry Cutter. NOTE: When removing the last
Thumb Nut, hold on to the Cutting Plate, failure to do so, may result in the Cutting Plate falling causing
damage.
2. To remove the Pushing Plate, with the Handle in the down position, remove the 2 Push Plate Screws
from the top of the Pushing Plate.
3. Once the Push Plate Screws are removed, raise the Handle and remove the Pushing Plate.
4. Replace the Pushing Plate and secure with the 2 Push Plate Screws.
5. Replace the Cutting Plate and secure with the 3 Thumb Nuts and Washers.
NOTE: The Cutting Plate needs to be facing inward (FIGURE 2).
The dull portion of the Blades should be facing outward.
Push Push
Plate Plate
Screws Screws
CAUTION
Cut Hazard. The cutting plates are sharp. Use care when handling.
FIGURE 2
Cutting
Plate
Blades
facing
inward