Led Status; Hardware Installation; Software Installation - Steren COM-858 Manual De Instrucciones

LED STATUS

HARDWARE INSTALLATION

1. Locate an available CardBus slot on your laptop.
2. With the connector pin end facing the CardBus slot and the
label facing up, slide the Adapter into the CardBus slot until it
locks in place.
3. The Status LED should fl ash when the Adapter is installed
correctly.

SOFTWARE INSTALLATION

The Adapter's Setup Wizard will guide you through the
Installation procedure for Windows 98Se, ME, 2000, XP. The
Setup Wizard will install the Wireless Client Utility (SWCU) and
drivers.
When you install the hardware before installing the software, the
system will prompt "Found New Hardware Wizard" window, click
Cancel, and run the Setup Wizard program on the CD-ROM.
The Setup steps for Windows 98Se, Me, 2000 and XP are very
similar. The following setup steps are for Windows 2000.
1. Insert the Resource CD into your CD-ROM drive, click Start
and choose Run. In the fi eld that appears, enter F:\XXX\Setup.
exe (if "F" is the letter of your CD-ROM drive; XXX is the setup
program path, which is labeled on the Resource CD), fi gure 1
should then appear.
ENGLISH-3