Conceptronic CSATA2P Guía De Instalación Rápida página 10

ENGLISH
3.2 Pre-install Windows 2000/XP
1. Reboot the computer and insert the Windows Installation CD-ROM in your CD-ROM
drive.
2. Insert the pre-install Driver Disk in the Floppy drive.
3. When the message below appears, press "F6" to specify the Driver Disk.
4. Follow the onscreen instructions for installing the driver and continue the Windows
installation.
Note: When Windows is installed on your computer, you need to install the driver
through the CD-ROM menu. It is advised to do this as first installation before you
proceed with the installation of other drivers and software. The installation of
the driver is described in chapter 4.
3.3 Pre-install Windows Vista
1. Reboot the computer and insert the Windows Installation CD-ROM in your CD-ROM
drive.
Follow the Windows Vista Setup Wizard until you can select the location for Windows
Vista.
2. Click the button "Load Driver".
3. Insert the pre-install Driver Disk in the Floppy drive or connect the pre-install USB-
Flashdrive to a free USB Port and click "OK".
4. Follow the onscreen instructions for installing the driver and continue the Windows
installation.
Note: When Windows is installed on your computer, you need to install the driver
through the CD-ROM menu. It is advised to do this as first installation before you
proceed with the installation of other drivers and software. The installation of
the driver is described in chapter 4.
10