Timer Control; Wireless Remote Control; Replacing The Fuse - Beamz Rage 1800 Manual De Instrucciones

TIMER CONTROL

Press the Timer key to activate the timer function. The display shows the adjusted interval and the device counts the seconds
down to "0". After that, the fog emission is triggered at the volume adjusted under "Volume Out". The duration depends on the
settings adjusted under "Duration Set". If you wish to deactivate the timer function, press the Timer key once more.
Manual control (locked)
Press the Lock button for immediate triggering of the fog emission at the volume adjusted under "Man Volume". Press the lock
button more in order to stop the fog emission.
Manual control (100% output)
Press the Manual key for immediate triggering of the fog emission at 100 % volume. Let the Manual key loose in order to stop
the fog emission.
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX-output of the controller directly to the DMX-
input of the first unit in a DMX-chain. Always connect the output of one unit with the input of the next unit until all
units are connected. If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
Address Setup:
Press the MODE button a number of times until Add appears on the display, with the UP / DOWN buttons the start address may
be set. The start address is defined as a first channel to which the machine will respond to. Check that there are no overlapping
channels used!

WIRELESS REMOTE CONTROL

The wireless remote control have 4 buttons. Press one of the buttons (A,B,C or D) and the machine will produce
snow as long as you press the button.
CLEANING
After each use and before storing the device, use clean distilled water for cleaning the machine.
Procedure:
Turn off the power and pull out the plug from the socket.
1.
2. Remove snow fluid from the tank.
3. Add clean distilled water in the tank.
4. Plug the power lead and switch power on.
Run the machine until the tank is almost empty. Caution: Do not let the pump run dry!
5.
Caution: Do not refill the tank with snow fluid if storing the snow machine.

REPLACING THE FUSE

If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
ACCESSORIES
High quality snow fluid on water basis, specially designed for Beamz snow machines guarantees a
trouble-free use.
1 litre pack Snowfluid, Ref no. 160.578
5 litre pack Snowfluid, Ref no. 160.579
5