K Tool International KTI75146 A Guia De Inicio Rapido página 3

ASSEMBLY INSTRUCTIONS
Step 5: Attaching Bottom Tray and Drawer
Assembly to Legs
Align holes in legs with matching holes in bottom
tray and drawer assembly as shown in figure 5.
Insert bolts through legs and into bottom tray
and/or drawer assembly and secure from the
inside with leg star bolts until all side holes have
been attached and hand tightened.
Step 6: Attaching the Handle
(A) Align the other legs with the front corners of
the bottom tray and drawer assembly. Align the
hole on the handle with the second hole down
on the drawer assembly and (unattached) leg as
shown in figure 6. Insert M8 x 19 handle bolts
through handle, through the legs and into the
drawer assembly as shown in figure 6. Secure
with star bolts from handle bolt kit and hand
tighten.
(B) Attach remaining M8 x 17 bolts (on the
opposite side from push handle) directly into
legs.
Step 7: Securing Legs
Using two people, turn the cart upright. Continue
to bolt through aligned holes in the front and
back of the cart with the M8 x 17 bolts, star bolts
as shown in figure 7. Hand tighten. ALL holes
should now be aligned and secured.
Step 8: Tightening Bolts (not shown)
Use a T40 driver to tighten all bolts
pressure to bolt head while tightening to keep
in correct position. Once all bolts are tightened,
your cart is complete. See page 4 for parts
breakdown.
KTI75146 A
. Be sure to apply
5.
6.
7.
3 rev. 04/04/17