Motion Remote - Engel EN1007M Manual De Usuario

Off
Network
ON - Amber
LED A- Off
LED A- Amber
Network
LED B- Blue
LED B – Off
Hardware Reset:
In the event that your ATV freezes operation, you can press the "pinhole reset" button,
located on the back the device, by using a sharp object such as a toothpick.

MOTION REMOTE

MOTION REMOTE
1
4
5
8
9
11
No Ethernet connection
Connected to the network
Transmitting/Receiving data
Complete initialization
Initializing
Connected to AC power supply
No power is supplied to the device.
1. Navigation Key
2. Mute
3. Home
2
4. VOL+
3
5. VOL-
6. Exit
6
7. Notifi cation
8. Menu
7
9. OK
10. Zoom In
10
11. Zoom Out
Notes: Notes:
Press Navigation key to active or lock remote control. Press Navigation key to active or lock remote control.
If you can't use remote control any more, please try to If you can't use remote control any more, please try to
check codes: check codes:
Press" mute + Zoom Out" buttons together for 3 se- Press" mute + Zoom Out" buttons together for 3 se-
conds, LED will quickly fl ash, then slowly fl ash for three conds, LED will quickly fl ash, then slowly fl ash for three
times within 15 seconds, this means successfully done.. times within 15 seconds, this means successfully done..
If there is no any LED light on the remote control, it If there is no any LED light on the remote control, it
means there is no power, please connect micro USB means there is no power, please connect micro USB
cable to charge up the battery, and the left red LED will cable to charge up the battery, and the left red LED will
sparkle while charging. sparkle while charging.
33