Courtyard Creations XTM011R Instrucciones De Montaje

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE!
PARTS LIST
PART
MATERIAL CODE
NO.
1
XTM011R-CS04-4
2
XTM011R-CS04-3
3
62XTM011RQ101
4
XTM011R-CS02-1
Attention:
Make sure that each bolt needed for all steps matches
the corresponding figure to ensure proper assembly.
Step 1:
Place the right leg (#1) onto a non-abrasive surface,
such as a carpet, with the brackets facing upwards.
Insert the braces (#3) into legs (#1 and #2). Fasten
them together by using bolts (#5). Keep the bolts loose.
See Figure 1.
Note:
1. The labels marked "L" and "R" on legs (#1 and #2)
should coincide with Figure 1 to ensure proper
assembly.
2. The holes in the braces (#3) must be facing towards
the inside.
Use the correct bolts as indicated. Do not tighten any of the bolts until the ottoman is completely assembled.
!
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings
!
required.
Keep children away during assembly. This item contains small parts that can be swallowed by children.
!
Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
!
Quote the following FQC No. when contacting the service center.
!
V-3
INTENDED FOR RESIDENTIAL USE ONLY.
XTM011R
PART Q'TY
RIGHT LEG
LEFT LEG
BRACE
SEAT ASSEMBLY
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
STOP DO NOT RETURN TO THE STORE!
PAGE 1 OF 2
PART
MATERIAL CODE
NO.
1 5
17C40A0702001YX
1 6
17C40A0712001YX
2 7
17KAA0101----Y4
1 8
17KAC3101----Y3
FIGURE 1
3
PART
BOLT M6*10
BOLT M6*35
HEX. KEY WRENCH 4MM
HEX. KEY WRENCH 10MM
2 L
5
3
1
R
10
#5 BOLT M6*10
COURTYARD CREATIONS INC.
Q'TY
4
4
1
1