Care Instructions; Your Product; Precautions For Use - Hesperide 117709 Manual De Instrucciones

CARE INSTRUCTIONS

1/ Your product

Properties
Epoxy steel is a steel covered with a protective paint against rust. Galvanised steel is steel
covered with a layer of zinc that allows it to be protected against corrosion. It protects furniture
long-term. The steel is then painted for an anti-corrosive effect.
Cataphoresis steel: Cataphoresis or electrocataphoresis is the most effective procedure for
fighting against corrosion. The steel is painted in a very uniform way thanks to the total
immersion of the furniture in a paint bath, then it's treated with epoxy and finally baked in an
oven.
Manufacturing and assembly
The manufacturing then assembly of this product requires leaving clearance between the
different parts.
It is therefore normal to observe gaps/slack that may reach several millimetres between the
different assembled elements (between two slats, between boards...).
This tolerance necessary for the correct realisation of your product can be behind little
geometric differences.
This does not lead to any loss of function of your product.
Irregular appearance
Each product is manufactured and assembled industrially from parts whose surface treatment is
carried out individually, before assembly. These metallic elements cannot be free from
appearance irregularities coming both from the surface treatment process and assembly
operations. The final appearance of the product is therefore directly linked to these possible
irregularities.

2/ Precautions for use

Do not put hot objects on the table itself, they will leave permanent marks on it (discoloration,
deformation, cracks...). Always use table mats.
Do not use a plastic tablecloth on the table. Exposed to UV and heat, it would melt and act as a
decal, especially on steel, aluminum and glass. This would result in irreparable deterioration of
the tray in the form of white streaks. Instead, use a fabric tablecloth.
3/ Maintenance and ageing, siding
It is normal to note natural wear and tear of the product over time and with use, in the form of an
alteration of the colours and the state of the surface, the mechanical functions and tightening of
the screwed elements.
Exposure to UV rays
Over time, you can see a discoloration of the materials exposed to UV rays (textiles, paint,
plastics), a phenomenon also due to the rays of the sun as well as those of the moon. This
evolution of colours exposed to external elements is normal and concerns in particular bright
colours.
Tightening
The assembly parts of your product become loose over time. Think of tightening them regularly.