FactorRACK FR-419 Manual De Usuario página 11

8.- I an individual hoist runs in the wrong direction. Check the cabling and check the hoist.
9.- Make sure that the load, that needs to be lifted, is in the correct position Clear the area from any obstacles that
could jeopardize the operation. No people are allowed under, on or in the vicinity of the load. Make sure all people
have left the operating area, before you start to move any load
10.- Pre-select all hoist needed in the up or down direction
11.- Press the green RUN button to activate all hoist and hold the RUN button until the load has reached the desi-
red height. It may be necessary to level the rig at certain stages
12.- Never press the run button staccato (=often pressing the RUN button within a few seconds). This can severely
damage controller and hoist.
13.- If the desired height is reached, release RUN button and press the red emergency buttonRemove all packing
materials from the chainshoist controller. Check if all foam and plastic padding is removed. Connect all cables.
NEVER change the running direction of a hoist when the run button is pushed.
All 3 red LED ( L1, L2, L3) must be ON. Otherwise one of the phases is not present. Do NOT hoist.
Only use cable and connectors, which are in good condition.
Never connect more than one hoist per channel.
Make sure that the total current draw of the connected devices, does not exceed the maximum allowed input
current.
If the device has an additional Protective earth terminal, make sure it is properly connected to metal parts like a
truss.
This device is meant for professional use and should only be used in a professional environment
i
nstallation
Remove all packing materials from the chainshoist controller. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly. Always disconnect from electric
mains power supply before cleaning or servicing. Damages caused by non-observance are not subject to warranty.
11
¡¡¡ ATTENTION!!!
Manual de usuario / User Manual | FR-419 Chainhoist controller | Rev. Jan.2016 | www.siluj.com
e
nglish