TOW READY 20110 Instrucciones De Instalación

Installation Instructions
Directives de Montage
Instrucciones de Instalación
Trailer Tow Harness
Faisceau de Fils
D'attelage de Remorque
Arnés de Remolque
READ THIS FIRST:
Read and follow all instructions carefully
before beginning installation.
LISEZ CECI EN PREMIER:
Lire et suivre toutes les instructions
attenrivement avant le montage.
LEA ESTO PRIMERO:
Lea y siga todas las instrucciones cuida-
dosamente antes de iniciar la instalación.
20110-037 Rev. A
ENGLISH
TOOLS REQUIRED
Drill (3/32" & 1/4" Drill Bits), 2" Hole Saw,
Philips Head Screwdriver, Center Punch
1. Locate the vehicle's 7-way factory harness
on or near the rear bumper
connector, being careful not to break the locking
tabs e . Ensure that the mating surfaces are
free of dirt. Clean if necessary. Install the Trailer
Tow Harness between the mating plugs.
NOTE
Dodge version is rectangular.
2. Determine a suitable mounting point (usually
on the Driver's side between the rear post and
the wheel well area) and route the harness to
this location fg . When routing make sure
you have some extra length (approximately
4" or more) that will be needed in step 5.
In addition, make sure that the trailer's wire
harness has adequate length to reach this
point and that you have at least 5" of clearance
behind the mounting surface for installation
WARNING
Route the wire being careful to
pipes, heat shields, the fuel tank or any other
points that may pinch or break the wire.
h
NOTE
Cut away view of truck rail. Make sure there
is at least 5" of clearance for mounting.
3. Once a suitable mounting location is found,
drill a pilot hole using a drill and 1/4" bit
Re-check your mounting location and wire
lengths and then use your 2" hole saw to
finish cutting the mounting hole
10/14/05
d . Separate this
NOTE
If the
be notched or use a longer set of screws
(not provided) and mount directly into the
bedliner and body panel.
NOTE
Use
h .
to prevent future rusting (not provided).
CAUTION
avoid any hot
Verify what is behind any surface prior to drilling
to avoid damage to the vehicle and/or personal
injury. Do not drill into any exposed surfaces.
4. Using the
mounting hole locations with a center punch
k and then
NOTE
i . Use
to prevent future rusting (not provided).
CAUTION
j .
Verify what is behind any surface prior to drilling
to avoid damage to the vehicle and/or personal
injury. Do not drill into any exposed surfaces.
5.00" MIN.
vehicle has a bedliner it will need to
rust-proof coating in drilled areas
7-way end as a guide, mark the
drill four 3/32" holes as marked.
rust-proof coating in drilled areas
•
d
•
e
•
f
•
g
•
h
5. Route harness thru mounting hole and
connect the 7-way end to the harness
Using the 4 self- tapping screws, mount
the 7-way harness to the vehicle surface.
WARNING
All connections
Trailer Tow Harness to function properly.
Test and verify installation with a test light
or trailer once installed.
NOTE
On some vehicles you may need to add a
fuse or relay (not provided) to complete all
of the functions going to the 7-way. Consult
your owner's manual for locations.
6. Secure the harness to the vehicle,
using the cable ties provided.
WARNING
Route the wire being careful to
hot pipes, heat shields, the fuel tank or any
other points that may pinch or break the wire.
•
i
•
j
•
k
•
l
•
m
lm .
must be complete for the
avoid any