Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Step 1 - Connect the power bank to your Torch Coat Heater™ with the USB cable.
Step 2 - To turn on your TorchCoat Heater™ press and hold the power bu�on for 3
seconds un�l the light turns on. The light will cycle through the 3 heat se�ngs
un�l it remains red, on the high se�ng.
• Red- High
Step 3 -The ba�ery provided with your Torch can be placed in the convenient pocket
behind the heat pad or it can be placed in any other pocket the ba�ery can reach in
your jacket.
Note: The addi�onal 12'' of cable a�ached to your Torch was designed so the ba�ery
can be placed in a convenient inside pocket of your jacket if desired.
ADJUSTING THE POWER SETTINGS
To adjust the power se�ng, a�er turning on your Torch Coat Heater™ press the
power bu�on repeatedly to cycle through heat se�ngs.
TURN YOUR TORCH COAT HEATER
To turn the hea�ng unit off, press and hold the power bu�on for 3 seconds
un�l the light turns off. Or you can unplug the ba�ery.
Disconnect the Torch Coat Heater from the ba�ery. Hand wash or machine wash on
gentle without the ba�ery connected. Air dry, do not put the Torch unit in a dryer
as this may damage the wiring.
OPERATING YOUR TORCH COAT HEATER

POWER LEVELS

• Blue- Medium
TORCH WASHING INSTRUCTIONS
• Green- Low
OFF
5

Publicidad

Tabla de contenido
loading

Tabla de contenido