Resin Regeneration; Machine With External Water Softener; End Of Service - Bobeck HGS 540 Manual Del Usuario

INSTRUCTION MANUAL FOR DISHWASHERS
GB
In machines equipped with an external water softener, after a certain number of cycles, the display will
show the message 'SOFT. MAINT.'. This indicates that the resins of the external softener must be
regenerated.
This signal remains even when the machine is off. To eliminate it, press and hold, for at least five
seconds, with the machine off and the door open, the START key (3).
•
At the end of the day always drain the machine as described in the "Machine draining" section.
•
Disconnect the power supply by means of the main switch and close the external water
cock.
•
Perform routine maintenance and clean the machine as described in the "Maintenance" section.
•
If possible, leave the door ajar to prevent the formation of unpleasant smells inside.
Page 8 of 12

4.8 Resin regeneration

4.8.1 Machine with external water softener

4.9 End of service