Schneider SPG520TX Manual De Instrucciones página 10

INSTALLATION AND PREPARATIONS FOR USE
The appliance is supplied with an installation kit including adhesive sealing material and fixing
brackets&screws are included with the appliance.
• Cut the aperture dimensions as indicated in Figure - 6. Locate the aperture on the worktop such
that after the hob is installed the following reguirements are ensured;
Apply the adhesive sealing material "C" all the way
•
round the aperture on the worktop to match the
outher perimeter edge of the appliance. Ensure that
the junctions overlap at the corners and no gap is left
along the sealing material.
Insert the appliance into the aperture and fix in
•
position via the brackets (A) and screws (B).
Adjust the position of the brackets depending
on the thickness of the worktop as indicated in
Figure7 and tighten the screws evenly.
Carefully trim away the excess sealing
•
material "C" from around the appliance.
42 mm
t>20 mm
t
10
Min. A
Neighbourhood walls
60 mm
Combustible
40 mm
Non-combustible
*If your appliance have five hobs ;
C
60 cm Built-in Hobs 580 mm
70 cm Built-in Hobs 700 mm
c
A
B
Min. B
150 mm
50/100* mm
Figure 6
Figure 7