8. Do not use heater in basement or below
ground level.
9. Before connecting heater to the propane/LP
tank, make sure the heater regulator knob
is in the OFF position. Always connect and
light heater in areas free of open flames.
10. Mount the propane/LP cylinders vertically
(shutoff valve up). Secure them from fall-
ing or being knocked over and protect
them from damage.
11. IMPORTANT: Use only hose and regulator
assembly provided with the dual burner
tank top heater. Inspect hose assembly
before each use. If there is excessive
abrasion or wear, or hose is cut, replace
with hose assembly listed on parts list
before using heater. Hose and regulator
must be protected from damage.
12. The heater burner must be at least 2 ft.
(0.61 m) above the floor. Always attach
to propane/LP tank in an upright position.
Never operate a heater on its side or at-
tach to propane/LP tank in a horizontal
position. This could lead to dangerous
flare-ups or fire. Do not direct heat toward
propane/LP cylinders within 20 ft (6 m).
13. Maintain minimum clearance from nor-
mal combustible materials (like paper)
as follows:
Sides and Top
Front
Floor to Bottom of Burner
Locate 10 ft. (3 m) from canvas or plastic
tarpaulins or similar coverings and secure
them to prevent flapping or movement due
to wind action.
4
SAFETY
14. The appliance area be kept clear and free
15. If at any time gas odor is detected, IM-
16. Install the heater such that it is not directly
17. Position heater properly before use. Oper-
18. Due to the high surface and exhaust
19. Do not move, handle or service while hot
20. Before each use, check heater for leaks.
21. Keep all connections and fittings clean.
3 ft. (0.91 m)
22. Use only in accordance with local codes
6 ft. (1.8 m)
2 ft. (0.6 m)
www.factorybuysdirect.com
from combustible materials, gasoline and
other flammable vapors and liquids.
MEDIATELY DISCONTINUE operation
until the source of gas has been located
and corrected.
exposed to water spray, rain, dripping
water and/or wind.
ate only on a stable, level surface.
temperatures, adults and children must
observe clearances to avoid burns or
clothing ignition.
or burning. Do not attach or remove a hot
or operating heater from the propane/LP
tank.
Never use an open flame to check for
leaks. Apply a mixture of liquid soap and
water to all joints. Bubbles forming show
a leak. Correct all leaks.
Make sure propane/LP tank valve is clean.
Check "O" ring on heater inlet fuel valve
connector for damage before each use.
Replace if worn or damaged.
or, in the absence of local codes, with the
Standard for the Storage and Handling of
Liquefied Petroleum Gases ANSI/NFPA
58 and CSA B149.1, Natural Gas and
Propane Installation Code.
160946-01A