Problem Solution - Rockwell RK2852K2 Manual De Instrucciones

HIGH EFFICIENCY CORDLESS DRILL DRIVER
HIGH EFFICIENCY HAMMER DRILL

PROBLEM SOLUTION

1. WHY DOES THE DRILL NOT TURN ON WHEN YOU
PRESS THE SWITCH?
The Forward and Reverse Switch, which is on top of
the trigger, is positioned in the lock function. Unlock the
Forward and Reverse Switch putting it into the required
rotation position. Push the trigger and the drill will start to
rotate (See Fig.B).
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the Torque Adjustment Ring,
you can find the Torque Adjustment Ring between the
Chuck and the drill body. Position 1 is the lowest torque
(screw driving force) and position 22 is the highest torque
(screw driving force). Position
Regulate the Torque Adjustment Ring to a higher position
to reach the best result (See Fig.E).
3. I CAN NOT FIT THE BATTERY INTO THE BATTERY
CHARGER. WHY?
The battery can be inserted into the charger only in one
direction. Turn the battery around until it can be inserted
into the slot, the red LED Light should turn on when the
battery is charging.
4. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, as above, and having not used a
Battery Pack for a prolonged time will reduce the Battery
Pack working time. This can be corrected after several
charge and discharge operations by charging & working
with your drill. Heavy working conditions such as large
screws into hard wood will use up the Battery Pack
energy faster than lighter working conditions. Do not
re-charge your Battery Pack below 0
as this will affect performance.
MAINTENANCE
Remove the Battery Pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always store your
is for drill operation.
C and above 30 C
o o
power tool in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust. Occasionally
you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Use good quality accessories marked
with a well-known brand name. Refer to the accessory
packaging for further details. Store personnel can assist
you and offer advice.
Only use the appropriate accessories intended for this
tool. Accessory information can be found on the product
packaging, at a ROCKWELL dealer or on our website at
www.rockwelltools.com
ENG
13