Troubleshooting - Rockwell RK3441K Manual De Instrucciones

4-1/2" CompaCt CiRCulaR Saw

tRouBleSHootiNG

Symptom
Tool will not start when
operating the on/off switch.
Cutting depth is less than
that is set.
Blade spins or slips
Blade will not cut a straight
line.
Blade kicks back when
beginning a cut.
possible Causes
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn down.
Sawdust accumulated at the rear
of the base.
Blade is not tightly engaged with
the spindle.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided properly.
Blade is not spinning fast enough.
possible Solution
Check to make sure power cord is connected
well into a working outlet.
unplug the power cord. Replace it using a
qualified maintenance person.
Replace the carbon brush using a qualified
maintenance person.
Shake out sawdust. Consider connecting a
vacuum for dust collection.
Remove the blade, and reassemble it as
described in iNStall /CHaNGe tHe BlaDe
section.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
use a parallel guide.
allow the saw blade to reach full speed prior to
beginning a cut in the material.
eNG
11