How To Use - COOSII Hello T1 Manual Del Usuario

How To Use

Charging
1. Connect the charging port with any USB charging
adapter or active computer USB port.
2. Charging will start automatically with the charging
indicator turning red.
3. The speaker is fully charged when the charging indicator
turns off.
Pairing
1. Turn on the speaker by pressing and holding the Power
Button for 2 seconds.
2. Once the speaker is on, it will go into pairing mode
automatically and the Bluetooth
3. Activate the Bluetooth function on your device and
®
search for nearby Bluetooth connections.
For iOS: Settings > General > Bluetooth > On
For Android: Settings > Bluetooth > On > Scan for devices
4. Select " T1" from search results and tap to connect.
5. The Bluetooth indicator will turn solid blue and there will
®
be a beep sound to indicate a successful connection.
Note:
• Please make sure no other open Bluetooth
within range, and the speaker is within 3 feet of your
device.
indicator will ash rapidly.
®
®
®
®
devices are
®
• The speaker will attempt to pair with the last paired device
when powered on. If you have previously paired the
speaker with a device, simply turn on your device and the
speaker, they will pair automatically without going into
pairing mode.
• If a PIN code is required for pairing, please try "0000"
or"8888" (4 zeroes or 4 eights).
AUX Mode
Connect any device to the T1 using a 3.5mm AUX cable.
Turn on the speaker and play music through AUX mode.
Note:
• When an AUX cable is connected to the speaker,
Bluetooth will be disabled.
®
• There will be a beep sound when a cable is
inserted/removed.
Troubleshooting
Q:My speaker will not switch on.
A: Please recharge it and make sure it has enough power.
Plug the unit into a charger and see if the LED indicator
becomes solid red.
Why can't I pair this speaker with other Bluetooth devices?
Q:
A: Please check the following:
• Your Bluetooth device supports the A2DP prole.
®
• The speaker and your device are next to
each other (within 3 feet).
®
07/08