Publicidad
EN
USING YOUR APPLIANCE
PLEASE READ THE "IMPORTANT SAFETY INSTRUCTIONS' IN THIS PUWEIKE OPERATING
MANUAL BEFORE PROCEEDING.
OPERATION
• Do not use outdoors or on wet surfaces or to vacuum water or other liquids -electric
shock could occur.
• Ensure the appliance remains upright in use and in storage. Dirt and debris may be
released if it is turned upside down.
• Do not operate while checking for blockages.
• For domestic indoor and car use only. Do not use it whilst the car is in motion or while
driving.
• This product has carbon fibre brushes. Take care if coming into contact with them, as
they may cause minor skin irritation. Wash your hands after handling the brushes.
DOCKING STATION INSTALLATION
• Use appropriate mounting hardware for your wall type and ensure that the docking
station is mounted securely. Ensure no pipework (gas, water, air) or electrical cables,
wires or ductwork are located directly behind the mounting area. The docking station
must be mounted in accordance with regulations and applicable codes/standards (state
and local laws may apply). PUWEIKE recommends the use of protective clothing,
eyewear and materials when installing the docking station.
CARPETS OR HARD FLOORS
• Before vacuuming your flooring, rugs and carpets, check the manufacturer's
recommended cleaning instructions.
• The brush bar on the appliance can damage certain carpet types and floors. Some
carpets will fuzz if a rotating brush bar is used when vacuuming. If this happens, we
recommend vacuuming without the motorized floor tool and consulting with your
flooring manufacturer.
• Before vacuuming highly polished floors, such as wood or lino, first check that the
underside of the floor tool and its brushes are free from foreign objects that could
cause marking.
LOOKING AFTER YOUR APPLIANCE
• Do not carry out any maintenance or repair work other than that shown in this
PUWEIKE Operating Manual, or advised by the PUWEIKE Helpline.
• Only use parts recommended by PUWEIKE. If you do not this could invalidate your
guarantee.
• Store the appliance indoors. Do not use or store it below3°C (37.4°F). Ensure the
appliance is at room temperature before operating.
• Clean the appliance only with a dry cloth. Do not use any lubricants, cleaning agents,
polishes or air fresheners on any part of the appliance.
VACUUMING
• Do not use without the clear bin and filter in place.
• Fine dirt such as flour should only be vacuumed in very small amounts.
• Do not use the appliance to pick up sharp hard objects, small toys, pins, paperclips,
etc. They may damage the appliance.
• When vacuuming, certain carpets may generate small static charges in the clear bin or
wand. These are harmless and are not associated with the mains electricity supply. To
minimize any effect from this, do not put your hand or insert any object into the clear
bin unless you have first emptied it. Clean the clear bin with a damp cloth only. (See
'Cleaning the clear bin'.)
• Use extra care when cleaning on stairs.
• Do not rest the appliance on chairs, tables, etc.
• Do not press down on the nozzle with excessive force when using the appliance as
this may cause damage.
• Do not leave the cleaner head in one place on delicate floors.
• On waxed floors, the movement of the cleaner head may create an uneven luster. If
this happens, wipe with a damp cloth, polish the area with wax, and wait for it to dry.
EMPTYING THE CLEAR BIN
• Empty as soon as the dirt reaches the level of the MAX mark- do not overfill.
• Ensure the appliance is disconnected from the charger before emptying the dear bin.
Be careful not to pull the 'ON' trigger.
• To make emptying the clear bin easier, it is advisable to remove the wand and floor
tool.
• To release the dirt, push the red button by the clear bin: Press once to open the bin
base. Press a second time to release the clear bin from the main body of the appliance.
• o minimize dust/allergen contact when emptying, encase the clear bin tightly in a
plastic bag and empty.
• Remove the clear bin carefully from the bag. Seal the bag tightly, dispose of as
normal.
• Close the clear bin base so it clicks into place and is secure.
CLEANING THE CLEAR BIN
• Ensure the appliance is disconnected from the charger before removing the
clear bin. Be careful not to pull the 'ON' trigger. Remove the wand and floor tool.
• Remove the clear bin carefully.
• Clean the dear bin with a damp doth only.
• Do not use detergents, polishes or air fresheners to dean the clear bin.Do not put the
clear bin in a dishwasher.
• Clean the cyclone shroud with the brush on the combination tool to remove lint and
dust.
• Ensure the clear bin is completely dry before replacing.
• To replace the clear bin, push the dear bin up and into the main body of the
appliance. It will click into place.
• Close the clear bin base so it clicks into place and is secure.
WASHING YOUR FILTER
• Ensure the appliance is disconnected from the charger before removing the filter. Be
careful not to pull the 'ON' trigger.
• Your appliance has one washable filter, located as shown. To remove the filter, lift it out
of the top of the appliance.
• Check and wash the filter regularly according to instructions to maintain performance.
• The filter may require more frequent washing if vacuuming fine dust or if used mainly
in 'Powerful suction' mode. Wash the filter with cold water only.
• Run water over the outside of the filter until the water runs clear.
• Squeeze and twist with both hands to make sure the excess water is removed. Lay the
filter on its side to dry. Leave to dry completely for a minimum of 24 hours.
• Do not put the filter in a dishwasher, washing machine, tumble dryer, oven, microwave
or near a naked flame.
• To refit, place the dry filter back into the top of the appliance. Make sure it is seated
properly.
LOOKING FOR BLOCKAGES
• Ensure the appliance is disconnected from the charger before looking for blockages.
Be careful not to pull the 'ON' trigger.
• Do not operate while checking for blockages. Failure to do so could result in personal
injury.
• Beware of sharp objects when checking for blockages.
• To gain access to blockages in the floor tool, remove the base plate by using a coin to
loosen the screw marked with a padlock.
• If you cannot clear an obstruction you may need to remove the brush bar. Use a coin
to unlock the fastener marked with a padlock. Remove the obstruction. Replace the
brush bar and secure it by tightening the fastener. Ensure it is fixed firmly before
operating the appliance.
• This product has carbon fibre brushes. Take care if coming into contact with them, as
they may cause minor skin irritation. Wash your hands after handling the brushes.
• Refit all parts securely before using.
• Clearing blockages is not covered by your guarantee.
BLOCKAGES- THERMAL CUT-OUT
• This appliance is fitted with an automatically resetting thermal cut-out.
• Large items may block the tools or nozzle. If any part becomes blocked the appliance
may overheat and automatically cut- out.
• Leave to cool down for 1-2 hours before checking the filter or for blockages. Ensure
the appliance is disconnected from the charger before looking for blockages. Failure to
do so could result in personal injury. Clear any blockage before restarting. Refit all parts
securely before using.
• Clearing blockages is not covered by your guarantee.
CHARGING AND STORING
• This appliance will switch 'OFF' if the battery temperature is below 3°C (37.4°F). This is
designed to protect the motor and battery. Do not charge the appliance and then
move it to an area with a temperature below 3°C (37.4°F) for storage purposes.
• To help prolong battery life, avoid recharging immediately after a full discharge. Allow
to cool for a few minutes.
• Avoid using the appliance with the battery flush to a surface. This will help it run
cooler and prolong battery run time and life.
Diagnostics - battery
When in use, trigger pressed (light on cleaner):
3 solid blue lights: ON
1 flashing blue light: No power
When charging the battery (light on battery):
solid red light: charging
solid blue light: charging complete
red light/blue light exchanged flashing: fault
BATTERY SAFETY INSTRUCTIONS
• If the battery needs replacing please contact the PUWEIKE Helpline.
• Use only PUWEIKE chargers for charging this PUWEIKE appliance.
• The battery is a sealed unit and under normal circumstances poses no safety
concerns. In the unlikely event that liquid leaks from the battery do not touch the liquid
and observe the following precautions:
10
Publicidad
