Richen Helia EF197A Instrucciones De Operación página 37

E N
N OT E: It is normal for the fan heater to stop running for some time. This
happens because the room temperature is at or above the temperature
set on the remote control. The heating indicator is switched off after
10 seconds when the flame is on. The heating indicator stays on when
you only use the heating function.
TI M E R
H I N W E I S: This setting only applies to normal mode. This allows the unit
to switch to standby mode after a cer tain period.
Press the button to switch between the settings OFF and 0.5 hours to
9 hours. The timer logo and time are displayed on the screen. The heater must
be in the ON position. The heater can be operated automatically using the daily
timer and the weekly timer on the remote control. Set the day, time and your
desired temperature.
Press the button to activate the remote control. Press and hold the M button
for three seconds to display the settings screen. Press the
select the day, time or your desired temperature. The selected function is high-
lighted. Press the '+' and '-' button to set the value.
• Time: 24-hour system
• Select your desired temperature from 15–25 °C .
• Temperature unit: °C , °F
TI M E R FO R DA I LY H E ATI N G
The following times are preset heating times that can be altered if desired.
6:00 a.m. to 8:30 a.m., 5:00 p.m. to 10 p.m.
Press the M button until
and then enter the daily heating interval. Press
six seconds to display the daily timer settings. Maximum three heating periods
per day.
• Press or to select hour or minute, press '+' or '-' to set the time.
• The minute indicator will increase/decrease by 15 minutes per press.
• Press and hold the button for three seconds or wait 10 seconds to save
and exit the heating time setting.
D
is displayed in the upper right corner of the screen
and button to
and hold the arrow button for
37