Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
□
Remove the canopy ring (L) from the canopy (C) by turning
the ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (JJ) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (II) in the round
holes. This will enable you to remove the mounting bracket
(A).
JJ
3
Assembling the fan
WARNING: Failure to properly install the locking pin (EE)
could result in the fan becoming loose and possibly
falling.
□
Loosen, but do not remove, the setscrews (HH) on the collar
on top of the fan-motor assembly (D).
□
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan-motor
assembly (D).
□
Carefully inset the hanger pin (DD) through the holes in
the collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (DD) against the wiring inside the ball/
downrod assembly (B).
□
Insert the locking pin (EE) through the hole near the end of
the hanger pin (DD) until it snaps into its locked position.
□
Re-tighten the setscrews (HH) on the collar on top of the
fan-motor assembly (D).
2
Routing the wires
□
Make sure the slot openings are on top and route the
wires exiting the top of the fan-motor assembly (D)
through the canopy (C) and the canopy ring (L) and then
through the ball/downrod assembly (B).
A
II
C
L
7
DD
Please contact 1-855-HD-HAMPTON for further assistance.
C
L
B
D
B
EE
HH
D
HAMPTONBAY.COM