Publicidad
INSTRUCTIONS
Assembly
Install and tighten air quick-connect
elbow with 17mm and 11/16" wrenches.
(see fig. 1)
Orient the grinder so that the power
switch faces up.
.1
.2
Align grinder spindle clamp so that the
square edge faces up. Push spindle clamp
onto grinder spindle body until it is flush
with the end. (see fig. 2)
Tighten the tool clamp with a 3/16" hex
key. (see fig. 3)
Center the grinder with spindle clamp
.3
attached between the pivot screws on the
machine. Evenly tighten both the left and
right pivot screws with a 3/16" hex key.
(see fig. 4)
.4
Pro-Anchor™ Pneumatic
8
Check the grinder's up and down
movement; the grinder should be firmly
in place, yet pivot smoothly and easily.
(see fig. 5)
Adjust pivot screws as needed.
Using a 9/16" wrench, tighten jam nut
on both pivot screws to lock pivot screw
position. (see fig. 6)
Push air tube into the air quick-connect
elbow. (see fig. 7)
Usage
For both pneumatic models:
Connect airline.
Install T-31 anchor bits with 1/4" shank
according to the grinder manufacturer's
instructions. (Anchor bits not included.)
Attach water hose and water source to
provide coolant during cutting.
Attach water hose to provide water as
coolant during cutting.
Use water control valve to adjust
coolant flow.
Aim water nozzle toward cut. (see fig. 8)
Usage tips continued on the next page.
9
.5
.6
.7
.8
omnicubed.com
Publicidad
