none FZ-18DL Manual De Instrucciones página 3

PLUG AND POWER CORD INSTRUCTIONS
This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit
situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing
instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse
blows, a short-circuit may be present and the product should be discarded or returned to an authorized
service facility for examination and/or repair.
REPLACEABLE FUSE
User Servicing Instructions
1. Unplug your fan. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by
pulling on cord.
2. Open fuse cover, located on the top of the plug, by using your thumb or a flat head screwdriver to slide
the cover down towards the prongs.
NOTE: Ensure that fuse cover is completely open before
remove fuse.
3. Remove fuse carefully by using a small screwdriver to pry the
the compartment by the metal ends of the fuse. (see Figure 1)
4. Place plug on a solid, flat surface. Insert new 2.5 Amp, 125
fuse compartment and use a small screwdriver to secure the metal ends
of the fuse into the compartment.
CAUTION: Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse.
5. Slide fuse cover closed completely. If fuse cover is difficult to close, make sure fuse is secured in place
completely by pressing down on metal ends of the fuse.
6. Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed.
Discard product if the attachment plug is damaged.
DO NOT OPERATE APPLIANCE IF THE POWER CORD SHOWS ANY DAMAGE, OR IF
APPLIANCE WORKS INTERMITTENTLY OR STOPS WORKING ENTIRELY.
ASSEMBLY INSTRUCTIONS
A
B
C
E
K
F
H
J
K
attempting to
fuse out of
Volt fuse into
D
M
O
G
P
I
3
Figure 1
Fuse
Fuse cover
Metal ends
L
N
Q