Menu 2 Programming - Sacs Aura 20U Instrucciones De Instalación

13 - MENU 2 PROGRAMMING

Parameter Description
Input
Display of the I/O state connected
to the card: photocells, loops, etc.
ONLY READING
If the input is active, the corre-
sponding code is displayed (see
Values)
Language
The language used by the station
is used
Change with UP and DOWN, con-
firm with PUSH
Address.
Station configuration
Change with UP and DOWN, con-
firm with PUSH
Gate
Station type and name
Change with UP and DOWN,
confirm with PUSH
Warmer
Express the temperature (in °C)
Thr. below which the heating resistor
is activated. Change with UP and
DOWN, confirm with PUSH
Values
0=Ticket request button pressed
1=INOPZ1 input active
2=Ticket slot photocell active (only
with KPM printer)
3=INOPZ3 input active
4=Detection loop active
5=Safety loop active
6=Barrier limit switch active
7=Entry station disabling active
(terminals 12/13)
To change the language, use the
AuraConfy software
033=Entry station 1
034=Entry station 2
035=Entry station 3
041=Exit station 1
042=Exit station 2
043=Exit station 3
049=Table validator1
050=Table validator2
051=Table validator3
057=Counter panel 1
058=Counter panel 2
059=Counter panel 3
IN1...IN3 = Input 1, 2 o 3
EXIT1...EXIT3 = Exit 1,2 o 3
POS1...POS3=Issuer 1,2 o 3
COUNT1...COUNT3 = Kit
NORA 1, 2 o 3
0...255
Default
-
IT
041
EXIT1
35
35 - Aura20 U