instructions are not complied with.
● This appliance is intended for domestic use
● In order to comply with safety regulations and to avoid hazards, repairs of electrical
appliances must be carried out by qualified personnel If repairs are needed, please send the
appliance to one of our customer service departments the address can be found in the
appendix to this manual.
● The appliance is not to be used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction.
●
Children being supervised not to play with the
● Before using the first time
Before the juicer is used for the first time, it must be cleaned as described in the section.
General Care and Cleaning Operation
-Open the storage compartment on the underside of the appliance and take out the juicer cone.
-Attach the juice container to the drive shaft of the base unit.
-Place the pulp sieve in the container.
-Fit the juicer cone on to the drive shaft.
-Push the spout upwards to ensure that the extracted juice remains in the container.
However, the juice may also be collected straight into a suitable container placed under the
spout: in this case, the spout must face downwards.
-Insert the plug into a suitable wall socket.
-Cut the citrus fruit in half and push one of the halves lightly down on to the cone with the cut
section facing downwards.
-The drive shaft will start rotating automatically once pressure is applied to the cone. The
appliance switches off when pressure on the cone is lifted.
-When processing larger quantities of fruit, the pulp sieve must be emptied from time to time
as necessary.
-To collect the juice, place a suitable container under the spout. Push the spout downwards.
The extracted juice passes now straight into the container. Once the desired amount of juice
has been collected, push the spout upwards again.
-Ensure the plug is removed from the wall socket after used.
only.
appliance.