Installing On A Table; Without Mounting Onto The Table - Yamaha RM-TT Manual De Instalación

INSTALLING ON A TABLE

Be sure to install this unit using the methods described in this manual.

Without mounting onto the table

1.
Plug the LAN cable into the Dante/PoE port.
Route through the cable slot as shown below.
NOTICE : Use STP (Shielded Twisted Pair) cable to prevent electromagnetic interference.
: When disconnecting the LAN cable from the Dante/PoE port, wait at least
five seconds before reconnecting the cable. Otherwise, damage or malfunctions
may result.
2.
Place this unit on the table.
This completes the installation.
LAN cable
RM-TT Installation Manual
11