Publicidad
Idiomas disponibles
Idiomas disponibles
Before you begin please read the following
GB
safety & user guidelines
English
Please ensure that your load is carried securely at
all times and in a way that will not endanger other
persons or road users.
When a load is carried on the roof of a vehicle, it will
change that vehicle's handling characteristics, notably
its susceptibility to side winds and its behaviour on
bends and under braking. It is recommended that you
drive with more care, reduce your speed and allow
for longer braking distances. Any heavier items stored
in the HandiHoldall
may be at risk of moving around
™
during transit and therefore care should be taken to
ensure that these items are secured within
the HandiHoldall
.
™
Please do not store the following items
in the HandiHoldall
:
™
•
Hazardous materials or chemicals
•
Food stuffs
•
Sharp items
•
Building materials
Liability
The following instructions must be followed carefully.
HandiWorld Ltd cannot accept liability for injuries or
damage caused by improper use of the product or
for any application of the product not outlined within
these instructions.
• The HandiHoldall
is designed for use with
™
the HandiRack
or with metal roof
®
• In the instance that the HandiHoldall
is being
™
used for smaller volume loads, we recommend
that all items are placed to one side of the bag
and that the storm flap on the opposing side is
folded and positioned to the underside of the
HandiHoldall
. Please be careful not to cover the
™
loops on the bottom of the bag.
• Intended for occasional use. Do not leave
permanently attached to the car.
• Please do not exceed the maximum speed limits
for the road and for your vehicle.
• Your HandiHoldall
should not be overloaded
™
and the contents not exceed the recommended
weight limit of 50kg. If the vehicle manufacturer
recommends a lower maximum load for the
vehicle's roof, please use this guideline.
• Please distribute your load evenly over the base
of the HandiHoldall
™
and ensure that items are
not free to move about whilst in transit.
• Check the tension of all fastening straps at regular
intervals during travel.
• Avoid removing the HandiHoldall
from the roof
™
of the car when it is fully loaded.
• Always remember to load your HandiHoldall
from the offside of the road.
• Do not drive with the HandiHoldall
unloaded.
™
• Your HandiHoldall
™
should always be stored
in a dry place and where necessary, cleaned
with a damp sponge using just warm water.
Step 1
(image 1 & 2)
Firstly and following the fitting guidelines, attach
the HandiRack
to the roof of the vehicle ensuring
®
that there is a gap of 25 - 50cm between the
two sets of bars. The HandiRack
pointing towards the front of the vehicle.
Step 2
(image 3)
Remove the HandiHoldall
and its component
™
parts from the travel bag and familiarise yourself
with the contents.
Step 3
Unclip the fastening belts, unroll the HandiHoldall
and unzip the top cover.
Step 4
(image 4)
Secure the 4 x support poles into the bottom of the
bag using the loops and Velcro fasteners.
Step 5
(image 5)
Lift the HandiHoldall
(unloaded) onto the
™
HandiRack
. Determine which line of loops on the
®
bottom of the bag, match the position of the 'D'
ring anchor points on the front and rear sets of
HandiRacks
. Please note that we recommend that
®
the front and back sections of the HandiHoldall
sit well over both bars of each HandiRack
Step 6
(image 6)
Start at the side on which the HandiRack
printed on the HandiRack
.
®
Step 7
(image 6)
™
Using one of the 2x3 metre HandiStraps
come with the HandiRack
, feed the HandiStrap
®
through the end 'D' ring, pass the HandiStrap
through the first two loops on the bottom of the
bag and then through the 2nd 'D' ring. Repeat this
procedure along the bottom of the HandiHoldall
Step 8
(image 7)
Feed the HandiStrap
on the opposing end of the HandiRack
Step 9
(image 8)
logo should be
®
Load the HandiHoldall
recommended guidelines and zip shut the top
ensuring that the zip pulls are positioned at
the back of the bag and that the storm flap is
secured to the Velcro on the lower section of the
HandiHoldall
. Please make sure that the storm
™
flap is in a vertical position to ensure that the
HandiHoldall
remains fully watertight during
™
transit.
™
Step 10
(image 9)
Pass the HandiStrap
of the bag. Repeat this process for the rear section.
Pass the HandiStrap
other side and fasten securely through the buckle.
Fasten tightly and ensure that the HandiStrap
is not snagged or twisted and tie-off any excess
strap. Repeat this process for the rear section.
Step 11
(image 10 & 11)
Recheck the fastening of the HandiStraps
™
.
®
Step 12
If the HandiHoldall
™
the compression straps located on the front and
logo is
®
back of the bag to ensure that the contents do not
move whilst in transit.
that
™
™
™
.
™
through the last 'D' ring
™
.
®
following the
™
through the 'D' ring on the top
™
through the 'D' ring on the
™
™
.
™
is not fully loaded, please use
Publicidad
