BABYHUB SLEEPSPACE Manual Del Propietário página 2

Congratulations on choosing the BabyHub SleepSpace, a practical, easy to use
and stable travel cot. The travel cot can be used for newborns and children up
to around three years of age
PARTS OF THE
BABYHUB SLEEPSPACE
Refer to these parts when
reading the instructions
ASSEMBLY
1. Unzip the bag
2. Lift out the cot
3. While holding the cot steady, pull up the telescoping white top. On first unpacking
there may be stiffness, in which case gently pull up one side a little and then the other.
4. Pull each upper leg upwards until the spring clips pop out above the lower legs
5. Open out the legs
6. Push down on the centre of the base
7. Pull up the middle of each side edge until the hinges click into place
FOLDING UP THE CRIB
1. Release the latches on the side which
has a diagram label attached/printed latch
diagram, and the opposite side
They have a latch which you slide open. You can
feel through the covers to slide them open.
This is how they work:
The other two sides simply need to be
pushed in towards the centre
2. Pull up the centre base until the
sides have folded in
3. If putting in bag: Push in the spring clips
on each leg and telescope the top down
4. Push down on the centre top firmly
but gently – DO NOT FORCE
5. To pack away in the bag, place the extra
padded mat inside the bag and insert
the folded up SleepSpace into the bag
USING THE ZIPPED DOOR
One side of BabyHub SleepSpace has a zipped
door for ease of use.
1. Undo the Velcro tab and snap fasteners on the
outer side in front of the zipped door and
fold up onto the middle frame out of the way.
Unfasten the fabric barrier and fold back
2. Unzip the door
Telescoping Top
Legs
Spring Clips
Hinge
Centre Base