Plein-Aircon
OPERATION
˅ TIME ˄
CLOCK
SLEEP
LOCK
●
There is a 3-minute delay between start-ups to protect the compressor.
●
The MIN-MAX button, located on the air diffuser (fig. 04), allows the user to choose the power
according to his or her needs: MIN (minimum power) - MAX (maximum power).
The system is always activated in MIN mode, even if it was in MAX mode when it was previously
switched off.
Each press of the button corresponds to a change in the operating mode between MIN and MAX.
The active operating mode is indicated by the corresponding LED lighting up: MIN = green; MAX
●
= red.
The start-up duration of the active LED is set to 5 minutes; after this time it turns off not to disturb
with its brightness, for example, the night rest.
The MAX mode of operation may remain active indefinitely; therefore, even if the system is
safeguarded by the BATTERY SAVER system, attention must be paid to the residual charge of
the battery to which it is connected.
Treated air is distributed from the diffuser to the interior of the vehicle through two sets of slots, with
the possibility of directing the flow by means of manually adjustable internal deflectors (fig. 05).
●
You can also choose to have more air from one side than the other and vice versa by manually
moving the internal deflector using the slider located in the center of the air diffuser (fig. 05).
It allows to modify the time in the dedicated functions.
It allows to adjust the time. Press CLOCK; then press SET to choose the digits to be
changed; press ˄ ˅ to change the chosen hour or minute.
Turns off the system after 8 hours from activation and during this time the temperature
gradually increases by 2° from the set temperature.
It works only in the following mode: air conditioning
Press the button with a pointed object to lock
The AUTO function
and the HEATING function
buttons on the remote control DOES NOT have any effect.
CAUTION
are disabled, so pressing the relevant
AIR DIFFUSER
15/40
.
/ unloack the keyboard.