STM ROBOTICS STM-1SM Manual De Instrucciones página 22

Instructions to configure operation settings
7. Turn on the heat press using the power switch, the heat press will make a long beep to indicate it
turned ON.
8. Press "MODE" and adjust minimum temperature to 165 C° using ← → buttons.
9. Press "MODE" again and adjust maximum temperature to 180 C° using ← → buttons.
10. Press "MODE" once again to adjust time to 15-25 seconds using ← → buttons.
11. Press "MODE" for last time to save the settings.
12. The press will start heating until it reaches the maximum temperature and will keep the
temperature between the minimum and maximum temperature set.
20