Skiddoü Malit Manual De Usuario página 11

E. Backrest position adjustment:
The seat backrest may be set in three positions (Fig. E2), wherein position 3 is tilted fully
backwards. To change the tilt angle of the backrest, lift the lever (8) upwards, as shown in Figure
E1, and then push the seat forward or pull it backwards to the desired position and release the
lever. The backrest will be locked in place. Always make sure that the locking pins are placed
correctly in the openings.
F . Seat level adjustment (Fig. F):
Stand in front of the high chair. Press the level adjustment buttons (7) on both sides of the seat
simultaneously and lift or lower the seat to the desired position. Release the button to secure the
seat at the desired level. There 7 chair levels available, with level 7 being the highest. Do not use
the chair in a position below 1. Caution! Never adjust the level while the child is in the chair!
G. Use of safety belts:
To secure the child in the high chair, check if the locks of the hip belts and the shoulder straps
are well connected or connect them, if necessary, then slide them into the buckle of the crotch
strap (Fig. G1) until they latch securely in place. Next, adjust the shoulder strap and the hip belt
to the body size of the child (Fig. G2). Press the central button to release the belt. The belts may
be installed in two positions, depending on the height of the child. Caution! Belts should be used
to ensure safety of the child. Use of the tray alone does not protect the child against falling out.
Always buckle the belts when the child is seated in the high chair.
Safety belt assembly/removal
Pull the plastic ring of the belt through the opening in the seat and the cover (Fig. G3). Repeat
this step for all belts and straps. The cover should be removed first to remove the belts from the
backrest. To assemble the belts, perform the same steps in reverse, first sliding the belts through
the opening in the cover and in the seat, such that the ring locks as shown in figure G4.
H. Cover removal:
To remove the upholstery, unlock the latches and pull the crotch strap from the seat. Next, pull
the top part of the upholstery from the seat and pull the belt ends from the backrest (Fig. H1).
WARNING - never use the product without the cover on.
I. High chair folding:
Press the leg folding buttons (9) simultaneously (Fig. I1) and then push the front leg forwards. When
you hear a "click", the high chair is secured in the closed position (Fig. I2). The removed tray may
be hung on the rear leg, as shown in Figure I3.
J. Care and maintenance:
Before each use make sure that the locking mechanisms operate correctly and check the product
regularly for damage.
Chair: Clean using a clean, wet cloth/sponge or use a mild detergent. Do not use solvents,
ammonia or petroleum. The product should be wiped clean after each use to avoid
discolourations.
Belts: Buckle up together. Wash manually. Do not bleach. Do not dry in a tumble dryer. Do not iron.
Do not dry clean.
10