ic-e Q5 EVOLUTION Manual De Usuario página 32

Introduction to the display
To turn on the display, first of all we will turn the key of the clausor and thus we will activate the
voltmeter.
Next, we press the central button on the right button and thus we will turn on the display.
Once turned on, by pressing the previous central button we can navigate between the different
specifications shown by the display such as:
- TRIP: shows the current mileage of the scooter..
- ODO: shows the total mileage of the scooter.
- CHARGE VOLTAGE of the scooter at those times.
- REMAIN: shows an approximate calculation of the mileage that we can travel with the
load that we have in those moments. This factor will depend on the weight of the driver,
speed, unevenness, etc.
- TIME: shows how long we have been with the scooter on.
With the buttons located at the bottom and top of the right button panel we can go up and
go down between the 3 speed levels where we can also see it reflected on the display. With the button
located on the left button panel we can choose between driving in normal mode
or sport mode where we can also see it reflected on the display.
To enter the display menu and thus see the different parameters, we must keep
pressing the upper and lower buttons on the right button panel at the same time. Pressing the
central button we will move through the programs and if we want to modify the value of the program,
we will raise or lower the number with the upper or lower key.
Once we reach the desired value, we keep the central button pressed until the scooter stops.
turn off and the new configuration will be saved.
In relation to the lights, it has rear indicators which we can activate by means of the button panel
located on the left side. It also has front and rear lights with a central focus as well as two lights led at
the botton just like a taillight. When we apply the brake, the circle on the screen flashes the same as the
rear light flashes too.
13