SANTAS BEST LED16 Guia De Inicio Rapido

8 PATTERN STARFLAKE SCULPTURE WITH TIMER
Please follow the instructions and information below pertaining to your
Starflake Sculpture.
In the event that you should encounter any issues during the assembly
of your Starflake; please refer to the "Troubleshooting" portion of this
manual or call our toll free customer service number at 1-888-831-6656,
and a trained representative will assist you.
Customer service hours of operation:
Monday-Friday: 8:00am – 4:30pm CST.
Holiday weekends:
Last weekend in November: 8:00am – 4:30pm CST.
First weekend in December: 8:00am – 4:30pm CST.
Visit us on the web at www.santasbest.com
ASSEMBLY INSTRUCTIONS:
No tools required.
Retain carton for storage.
1. Carefully remove assembled Starflake from the carton. Your Starflake
should include the following (Fig 1):
A completely assembled pre-lit Starflake
Replacement LED/RGB bulbs
Fig 1
2. To illuminate, fully insert the plug into a working GFCI outlet or an
outdoor rated extension cord.
The Starflake is now ready to hang on a flat surface by the eyelet at
the top of the Starflake frame.
8 PATTERNS:
Your Starflake Sculpture has been designed with 8 unique pre-set
lighting patterns. Once plugged in the Starflake will continually
sequence through each of the 8 pre-set patterns.
TIMER FEATURE:
Your Starflake Sculpture is equipped with a built-in timer. The timer is
activated when the item is plugged in.
TIMER MODE: A twinkle of "Red" three times indicates the timer is on.
Timer feature is 6 hours on/18 hours off. To switch to normal mode,
simply unplug and plug back in.
NORMAL MODE: A twinkle of "Red/Green/Blue" indicates the timer is
off. The sculpture will remain on until unplugged. To switch to timer
mode, simply unplug and plug back in.
8"
LED16
Fig 2
TROUBLESHOOTING
1. Failure to light; unplug the product and check to see that
the GFCI outlet is functioning.
2. A section fails to light; unplug the product and check all
light string connections. This product uses low voltage
coaxial connections. To connect the light strings; align the
male end to the female connectors as shown and connect
them together. Slide the screw cover from the "male"
connector over the "female" connector and tighten (Fig 2).
NOTE: Replacement bulbs are provided; this is a specialty
LED bulb. Do not attempt to replace with a standard LED
or incandescent bulb. Should you require additional bulbs
please contact our customer service department.
3. If the product still fails to light, please call our toll-free
customer service number for assistance at
1-888-831-6656.
DISASSEMBLY & STORAGE
1. Place the Starflake in the original carton.
2. Store in cool, dry location away from sunlight.
Replacement LED/
RGB bulbs
Made in China
Printed in China
This is not a toy, for decorative use only.
Distributed by Santa's Best®
Riverwoods, IL 60015 USA
www.santasbest.com
11.5"