CLAMCLEAT CL257 Manual De Instrucciones

Fitting onto a at or
curved surface
U
Mounting positions
Tiller
You can reduce slack in the
rope by putting the rope into
the teeth like this, before
pushing the cleat down.
Rope alignment
U
Setting the release load
Test Release load with "cam" at minimum setting.
1.
To increase release load use a screwdriver to
2.
rotate "cam" towards "maximum".
WARNING - To avoid damaging equipment, make
small adjustments and test each increase. Tests
show that release loads of 240kg (530lbs) are
possible with the cam at "maximum" setting.
Smaller or worn ropes release at higher loads
than larger or new ropes.
see the CL257 at www.clamcleat.com
CL257 Auto-Release Racing Mini
Fitting Instructions
4mm
5/32"
U
Use sandpaper
to achieve
a perfect fit on a
curved surface.
Minimum 200 mm (8")
Rudder
To aid rope alignment use a fairlead
©Clamcleats Ltd Welwyn Garden City AL7 1AP England
M4
#8 / 5/32"
1
4
U
3
When Mounting in positions
an elastic band to hold the tail of the rope.
7
Always keep the tail end of the rope tidy
CL257-Fitting-Instructions-colour.pdf
Tel +44 (0)1707 330101 email: sales@clamcleat.com
4mm /4.2mm
No 8
#220-#240
sandpaper
U
Fix
U
CL257
on
2 4
any
U
side of
a tiller
U
Elastic
Minimum 100 mm (4")
3-6mm
(3/16" - 1/4")
P
1 U
U
2
U
3
2,3 & 4 use
Fairlead.
Holt - HA4288
RWO- R2820
Ronstan -RF94
Tel.: +49 ( 0 ) 40 - 88 90 100
www.toplicht.de