Machine Installation; Electrical Connection; Filling The Water Tank - LaPiccola PICCOLA PICCOLA Manual De Instrucciones

4. MACHINE INSTALLATION

Note: in the machine there might be traces of coffee, these are attributable to tests carried
out by the Manufacturer to ensure the highest quality product. Before using the machine for
the first time, it is necessary to thoroughly clean its components; for further details see the
relevant paragraph.
Before operation, proceed to correctly install the machine. After removing the unit from its packaging, proceed as follows:
• Place the machine on a firm, flat surface;
• Make sure that it is not accessible to children;
• Keep it away from hot surfaces or open flames; Keep the machine at a distance of about 15 centimetres from other devices.
We recommend retaining the packaging for subsequent moves or transports.

4.1. Electrical Connection

Warning: Electric current can be dangerous! Therefore, always follow and adhere to the sa-
fety standards. Do not ever use faulty cords.
The operating voltage of the device is set at the factory; it is necessary to verify that the mains voltage matches the indications
on the technical data plate. Before connecting the machine to the power supply, ensure that both buttons are not pressed.
Insert the plug into a suitable power outlet.

4.2. Filling the water tank

To operate the machine fill the water tank.
Caution: To fill the tank, use only fresh drinking water; Hot water or soda can damage
the machine. Before starting the machine, check that there is a sufficient
quantity of water.
• (Fig.1) - Remove the cap from the water tank • (Fig.2) - Remove the tank from the machine.
• (Fig.3) - Fill the tank with fresh drinking water.
• (Fig.4) - Place the full tank in the machine, then place the cap on the tank paying attention to the tube inside, verifying that it
touches the base of the tank and there are no pressures that could potentially jeopardize the retrieval of water.
19