Blade Adjustment - NORSKE NMAP001 Manual Del Propietário

FIGURE 5
FIGURE 6
WARNING
VERY SHARP BLADE

BLADE ADJUSTMENT

ADJUSTING THE BLADE
1. Unscrew and remove the adjustment
plate screws (Fig. 5).
2. Tighten both adjustment plates by
1 or 2 holes (Fig. 6).
NOTE: The pitch on each lifting screw
is .125mm. The adjustment on both plates
must be the same.
ATTENTION! NO ADJUSTMENT IS NEEDED
ON ALL BRAND NEW UNITS.
CUT GUIDE
Your tool cuts a wide variety of products.
Please refer to this cut guide for
recommended products and thicknesses.
• Fiber Cement Siding ..................9.5mm
• Laminate & Vinyl Flooring ...........15mm
• Engineered Wood Flooring ..........15mm
• Vinyl Tile & Siding ........................15mm
- 5 -