Nexeo 2000 Manual De Usuario página 20

THERMOSTAT INSTRUCTIONS
1. Turn on the appliance according to the working conditions (fan, warm, hot ...). This
function is performed only by using the remote control.
2. To adjust the temperature, press"
temperature between 10ºC and 49ºC.
3. When the air temperature drops 2 degrees below the set temperature, the heater
will start heating with "
4. When the air temperature is 1 degree higher or equal than the set temperature,
the split will emit air for 30 seconds.
WEEKLY TIMER FUNCTION
1. Turn on the appliance according to the working conditions (fan, warm, hot ...). This
function is performed only by using the remote control.
2. Before turning on the heater, set the real time time.
WEEK Press "SET" button, "1" will flash the light, press "
the week from 1 to 7 (1 = Monday ... 7 = Sunday ect.)
HOUR Press the "SET" button again, the front LED display "00" will flash, press "
" two buttons to set the hours from 01 to 00 (01 = 1 o'clock, 02 = 2 o'clock ...
00 = 24 o'clock ) clock ect.)
MINUTE Press the "SET" button once more, the LED display behind "00" flashes,
press " " two buttons to set the minutes from 00 to 59 (01 = 1 minute, 02 = 2
minutes, etc.)
PS: Press the "SET" button, the display shows a number that will flash 5 seconds, it
must operate in time, otherwise the device will return to standby mode.
(The appliance will keep the correct time until it turns off)
DAILY TIMER FUNCTION
WEEK Press the button "
HOUR Press the button "
press " " two buttons to set the hours from 01 to 00 (01 = 1 o'clock, 02 = 2
o'clock ... 00 = 24 o'clock, etc.)
20
" to set the desired temperature and the
" (2000W).
"for the first time, "1" lights up, it means "Monday".
"2 times, the front LED display "00" flashes,
EN
" two buttons to set