GROUND FORCE FULL FORCE Instrucciones

INSTALLATION
INSTRUCTIONS
FULL
FORCE
Thank you for choosing Ground Force to secure your home. We hope you have many days and nights feeling a high level of comfort and security with our product.
We do recommend a professional installer. Please read all of the instruc ons carefully before beginning.
Tools required are as follows:
1) A variable speed drill ( used for drilling le, marble, granite)
2) A rotary hammer drill ( used for drilling concrete/masonry)
3) A 3/8" x 10" masonry bit ( used for drilling a pilot hole into concrete/masonry )
4) A 1" x 10" masonry bit ( used for drilling main hole for floor insert )
5) A 1" diamond pped hole saw bit ( used for drilling le, marble, granite )
6) A 1" Forstner bit ( used for drilling into wood )
7) A small tube of super strength anchor adhesive
8) Masking tape
Instruc ons:
A) Select the model that best suits your preference (Full Force, Delta Force or Task Force).
B) For Full Force model, determine which mode best suits your need. Fully Closed (unit flush against the door) or Par ally Open (unit set back from the door)
C) If the selected mode is Full Force-Fully Closed, stand the unit, on its stem, so that it sits comfortably against the door. with the rubber pad touching the door.
D) Typically, the posi on of the unit should be set approximately 3" to 4" in from the end of the door.
E) Using a marker, draw a circle around the stem on the floor.
F) Find and mark well, the center point of the circle.
G) Put masking tape over the circle. Allow for tape to be at least 1" on either side of the circle. (this will minimize any chipping or cracking when drilling)
H) Depending on the material of the floor, select either the bit described above (5 or 6) to drill down into the floor un l you reach through the wood or le using the
variable drill.
I) Make sure the drill is in a perfectly ver cal posi on and drill slowly un l you reach the concrete if that is your base material.
J) Remove le or wood debris from the hole.
K) Using the rotary hammer drill and the 3/8" masonry bit (3), drill a pilot hole into the concrete making sure the hole is in the center of the exis ng hole.
L) Using the 1" masonry bit (4), drill, in a perfectly ver cal posi on, down into the concrete approximately 3" and remove debris from the hole.
M) Take the Insert and place it into the hole making sure that the flange sits firmly on the floor around the hole.
N) Remove the insert. Remove the masking tape. Clean thoroughly around the area.
O) Squeeze a small amount of anchor adhesive into the hole and around the external surface of the insert. Place the insert firmly down into the hole. Clean the area
around the flange and allow to dry.
P) A er drying, your unit is now ready to install into the floor with the rubber pad si ng against the door.
Q) If you select to use the Full Force-Par ally Open mode, then open the door to the desired opening, place the unit against the door at the desired opening and with the
marker, draw a circle around the stem. Follow the installing instruc ons D to P above.
R) If you select to use the versa lity of the Delta Force model (Fully Closed & Par ally Open mode) then assemble the bolster piece to the main unit and follow the
installa on steps outlined for Full Force-Fully Closed (C) above. This will allow for the unit to be flush against the door when assembled with the bolster and in the
par ally open posi on when the bolster is removed.
S) If you select the Task Force model (double door system) then follow same the steps as with the Full Force model except change the hole posi on loca on at the seam
where the two doors meet.
www.groundforceinc.com
DELTA
FORCE

G
F
GROUND
FORCE
TASK
FORCE
832-421-0337