Publicidad
Idiomas disponibles
Idiomas disponibles
oUtlIne For UnDermoUnt
SInk CUtoUt
moUntInG BrACket
InverteD CoUntertoP
APPlY SIlICone SeAlAnt AFter CleAnInG tHe
SInk eDGe AnD CoUntertoP
verIFY SInk IS CentereD WItHIn tHe CoUnter-
toP oPenInG BeFore tIGHtenInG FAStenerS.
1. Following all local plumbing and building codes, install the faucet according to the manufacturer's instructions.
2. Connect the drain and piping.
3. Run water into the sink and check all connections for leaks.
d IMPORTANT: For additional information or warranty issues contact Belle Forêt directly at:
Belle Forêt Warranty Dept, World Imports Decorative Plumbing
3074 Chastain Meadows Parkway
Marietta, GA 30066
(800) 880-8164
Contact Belle Forêt at (800) 880-8164. Copyright ©2014, World Imports Decorative Plumbing. All rights reserved.
UnDermoUnt StAInleSS Steel SInk
1. Position the template (provided with your sink) front to rear so the sink
will not interfere with the cabinet; secure with tape.
2. Trace the template and remove. Dry fit the sink to verify the
measurements.
4. Following the countertop manufacturer's instructions, carefully cut the
countertop on the inside of the traced line.
5. Locate and drill the mounting holes, following the countertop
manufacturer's instructions. Holes should allow even spacing of mounting
brackets around the sink.
FAStener
6. With the countertop inverted (upside down), fasten the mounting brackets
to the countertop loosely.
d IMPORTANT: The cabinet must be installed, secured, plumb, and level
BEFORE installing the sink.
d IMPORTANT: Belle Forêt undermount sinks should only be fastened to a solid
surface countertop (i.e. granite, Corian® or Silestone®).
1. Clean the bottom of the countertop and the top flange (or lip) of the sink
with denatured alcohol.
2. Apply a narrow bead of silicone adhesive sealant evenly all around the top
of the sink flanges.
3. Position and align the sink over the countertop opening. Press silicone onto
countertop.
4. Tighten fasteners until mounting brackets are snug against sink. Check
alignment of sink to the countertop opening.
5. Tighten down fasteners evenly. Be careful not to over-tighten.
6. Immediately remove excess sealant.
d IMPORTANT: The enclosed cutout template will create a countertop opening
with a minimal (1/8" or less) reveal. It is recommended that you discuss
this with your installer and agree that this finished appearance is the
desired effect. Belle Forêt is not responsible for improper sink or countertop
installations.
d IMPORTANT: Belle Forêt is not responsible for sink or countertop if damaged
during installation. Be sure to inspect the sink for damage prior to beginning
installation.
Page 2
InStAllAtIon InStrUCtIonS
Publicidad
