Installation Steps - Rampage Products Trail Guard Front Bumper Instrucciones De Instalación

Installation Steps

Remove the 6 plastic fasteners holding on the front lower
air dam and remove. Earlier models you will need a Phillips
head screwdriver. Later models can just be pulled out by
1
Carefully pull bumper away from frame to expose the
fog light connections and wiring. Unplug fog lamps
and remove wiring from bumper as necessary,
remove bumper.
3
For 2012 and newer models some winches may require reloca-
tion of the vacuum pump. Remove hardware using a 10mm
5
NOTE: FOR '07-'11 MODELS SKIP THESE STEPS go to Step 9
Re install vacuum pump using (2) stand offs and (2) bolts and
(2) washers 2 Nuts. [spacer in the front is ¾" and the rear is 1" ]
7
NOTE: Actual application may vary slightly from illustrations.
hand.
socket.
Locate and remove the 8 nuts holding on the front bumper
(on both sides) using an 18mm socket.
2
Remove the fog lamps using a Phillips
head screwdriver, save lamps.
4
Remove 2 studs remaining hardware using a cut off wheel and
drill hole to clear for remount.
6
Mark the corner frame bracket then Cut trim as required on
both left and right side to allow for larger winches to clear.
8
Page 2 of 4