Setting Up Your Watch; Charging Your Watch; Disassembling / Assembling Your Watch - FITNIV IW2 Manual Del Usuario

Setting up Your Watch

Charging Your Watch

Please fully charge your watch before initial use.
1. Insert the USB plug of the charging cable into the USB port on your computer or a
UL-certified USB wall charger.
2. Hold the other end of the charging cable near the port on the back of the watch until it
attaches magnetically.
3. Make sure the pins on the charging cable lock securely with the port. The connection
is secure when the watch vibrates and the battery icon with percent charged appears
on the screen.
When the watch shows that the battery is low, connect the watch to
a USB port with 5V-500mA.
While the watch charges, there is a battery progress bar on the
screen and you can check the battery level at any time.
4. Remove the watch from the power supply once fully charged.
USB charger requirement: DC USB port (5V-500mA)

Charging time: Approximately 2 hours


Disassembling / Assembling Your Watch

Disassembly
1. To remove the wristbands, turn over the watch and find the quick-release lever.
2. While pressing the quick-release lever inward, gently pull the wristband away from
the watch to release it.
2