Hanging The Fan - THOMASVILLE LIGHTING Provence Serie Manual De Instalación

Hanging the Fan

REMEMBER to turn off the power.
Follow the steps below to hang your
fan properly.
NOTE: This ceiling fan is supplied
with two types of hanging assemblies;
the standard ceiling installation using
the ball/ downrod assembly mounting,
and the "close-to-ceiling" mounting.
The "close-to-ceiling" mounting is
recommended in rooms with less than
8-foot ceilings or in areas where
additional space is desired from the
floor to the fan blades. When using
standard downrod installation, the
distance from the ceiling to the bottom
of the fan blades will be approximately
14.5 inches. The "close-to-ceiling"
installation reduces the distance from
the ceiling to the bottom of the fan
blades to approximately 9 inches.
STANDARD CEILING MOUNTING
Note: For mounting angles between
20-45 degrees, please replace the
canopy bottom cover installed on the
bottom of the canopy opening with
the extra 45-degree canopy bottom
cover included.
1. Remove the canopy ring from the
All manuals and user guides at all-guides.com
canopy by turning the ring to the right
until it unlocks (Figure5).
Figure 5
2. Remove the mounting plate from
the canopy by loosening the four
screws on the top of the canopy.
Remove the two non-slotted screws
and loosen the slotted screws. This will
enable you to remove the mounting
plate (Figure 6).
Figure 6
3. Remove the hanger pin and
locking pin from downrod assembly.
4. Route the wires exiting the top of
the fan motor through the decorative
motor collar cover then the canopy
ring. Make sure the slot openings are
on top. Route the wires through the
canopy and then through
ball/downrod assembly (Figure 7).
5. Loosen, but do not remove, the set
screws on the collar on the top of the
motor housing.
the
4.